Pata'Mould silicon mass for moulds

Instructions :

• Take 1 volume of white Pata for 1 volume of blue mold.
• Mix until you get a clear blue uniform appearance.
• Apply progressively on the support starting from the center to hunt bubbles and leaving a minimum thickness of 2 mm.
• Wait 10 minutes then unmold gently.
• These silicone molds can be filled or cast with all types of clays (wepam, polymers, etc.), plasters, resins, etc.
• These molds can be used up to 50 times depending on the molded materials.

Curing time: 10 minutes

Thickness: from 1 to 10 mm

This box includes:

•      1 box "PATA" white 225 g
•      1 Box "Mold" blue 225 g

Resistance:

•      Heat: up to 120 ° C.
•      Water: Resists perfectly to moisture.